Pursit 2260 DENALI, Owner'S Manual

Page: 24 / 130

2260 DENALI
1-6
Fuel Gauge
The fuel gauge indicates the amount of fuel in the fuel tank.
Voltmeter
The voltmeter displays the voltage for the battery and the charging system. The normal voltage is
11 to 12 volts with the engine off and 13 to 14.5 volts with the engine running.
Hour Meter
The hour meter keeps a record of the operating time for the engine. The hour meter is located in
the engine compartment.
Tilt/Trim Gauge
The tilt/trim gauge monitors the position of the outdrive. The upper range of the gauge indicates
the tilt, which is used for trailering and shallow water operation. The lower range indicates the trim
position. This is the range used to adjust the hull angle while operating your boat on plane. Please
refer to Chapter 2 and the engine owner's manual for more information on the operation of the
outdrive power tilt and trim.
Engine Alarms
Some inboard/outboard engines could be equipped with an audible alarm system mounted in the
helm area that monitors selected critical engine systems. The alarm will sound if one of these
systems begins to fail. Refer to the engine owner’s manual for information on the alarms installed
with your engine.
IF THE ENGINE ALARM SOUNDS, IMMEDIATELY RETURN THE THROTTLE TO IDLE AND
MOVE THE SHIFT CONTROL TO THE NEUTRAL POSITION. SHUT OFF THE ENGINE
UNTIL THE PROBLEM IS FOUND AND CORRECTED.
Compass
The compass is on top of the helm. To adjust the compass for your area,
read the instructions on “Compass Compensation” given to you in the
literature packet. The compass cannot be adjusted accurately at the
factory as it must be compensated for the influence of the electrical
equipment and electronics unique to your boat. Therefore, the compass
should be adjusted by a professional after the electronics and additional
electrical accessories are installed and before operating the boat.
Depth Gauge
The depth gauge indicates the depth of the water below the bottom of the boat.
Compass