Purite SELECT NEPTUNE Analytical, User Manual, Page: 52 / 90

.5.5 Out Quality Alarm
m refers to which
ac’s can set to indicate repl . The set point
Ω -cm .
NB:
The capacity quoted for the NCP is to t point is
there will be a reduction in cartridge capacity.
5.5 Qual Alarm
refer at which the NCP media
can be pr replacem set point is
y pre set to m .
5.5 mp Alarm
wa exceeds the pre-set temperature
mp igh”
alarm message will be displayed.
o
C and can
ck Date
g the
RESET
button.
.5.9
Hours Date
this screen (see below) and pressing “
RESET
” the
will reset to “0” hrs and the date will change to
ture. The Hours run figure will rise according to
5
This alar the quality at the Right hand NCP
media p be pre- acement
is factory pre set to alarm at 10M
1M Ω . If the se
raised then
.6 Mid
This alarm s to the quality Left hand
pac e-set to indicate ent. The
factor alarm at 1M Ω -c
.7 Te
If the treated ter temperature
valve, a
“Te
The default temperature setting for the unit is set at 35
erature H
be accessed via the
“User Settings”
menu
Section 5.5
.
5.5.8 NCP (Right) Pa
Following installation of a new right hand side NCP Pack the date
of replacement must be reset. A date of 6 months hence is set on
pressin
5 Internal Filter Date
Following installation of a new internal 0.2 or 0.05 micron filter the
date of replacement must be reset. A date of 12 months in the
future is set on pressing the
RESET
button.
.5.10 185nm UV 5
Following replacement of a new 185nm photo-oxidation UV lamp
the future date of the replacement lamp must be reset. On
entering
Select Neptune Manual Iss: B
totalled hours run
12 mths in the fu
actual hours run and number of lamp on/offs. This also applies to
the forecasted date.
UV Lamp Run Hours
Replace @ 6000hrs
200Hrs
Forecast Change
Date
12/02/05
EXIT
RESET
MENU