Purite SELECT NEPTUNE Analytical, User Manual, Page: 35 / 90

rom the, “
Purified Water in
” and “
Drain
”
ports. To remove transit plug push in black collet and withdraw red
isolating valve to make any future
ance easier.
3.8.2 Drain
port. Then into the elbow, push in one end of a length of 8mm tubing.
a suitable drain, within 2 metres of the unit ensuring
the tubing is unrestricted and does run more than 1 metre above the
u
.8.3 Pressurised Outlet/Return
If the unit is to be configured to feed external equipment via the
Pressurised outlets, located at the rear of the unit, follow the
instructions below.
Using 2 of the 8mm stem elbows push the plain stem ends into the
“
Pressurised Water
“ ports. “ Cut
the 8mm tubing supplied to the required length for the external
equipment.
Then locate the small black
near the connections and turn so the
lever is at 90 Degrees to the body (Closed)
This will direct the water out and around the external loop.
Fig – 11 Pressurised Outlet Diverter Valve
Remove the red transit plugs f
transit plug (see appendix-A)
Using the 8mm tubing supplied, push one end into an 8mm stem elbow
and push the stem end into the “
Purified Water In
“connection on the
rear of the unit. Cut the tubing to length and connect up to purified
water take off, ideally via an
mainten
Using an 8mm stem elbow push the plain stem part into the “
Drain
”
Run the tubing to
nit
3
Out
” and
Pressurise Water Return
valve
Pressurised
outlet control
valve. ¼ Turn to
open for external
loop feed
.
Select Neptune Manual Iss: B