Puricom GuTZZI FT, Data Sheet Service Book

Page: 9 / 14

19
English
• When the system’s tap is turned on, the water sto-
red in the tank flows through a post-filtering stage (R)
whose aim is the elimination of possible odours and
taste, as well as pH level adjustment (depending on the
model), which the water may retain before being dis-
pensed.
• Depending on the model, the appliances may have di-
fferent functional and/or safety systems, managed by a
state-of-the-art electronic module:
• The equipment with a pump (P) control the filling of
the tank via a pressure switch (HPS).
ACUSTIC
INDICATION
4. INTERFACE. SYSTEM STATUS.
CONTROLLER PJK-266-B + PJK-049
VISUAL INDICATION
BLUE LED
“Power”
GREEN LED
“Water quality detector”
BLUE LED
“Power”
GREEN LED
“Water quality detector”
RED LED
“Leaking sensor/filters”
RED LED
“Leaking sensor/filters”
RED LED
“Leaking sensor/filters”
Electrically powered system.
-
-
-
x1
x1
x2
When the PUSH-button on the front panel is
pressed, it indicates thet the quality of water
produced is excellent.
When the PUSH-button on the front panel is
pressed, it indicates thet the quality of water
produced is poor.
Carry out the maintenance/change the filters
immediately. **
A water leak has been detected. Systen bloc-
ked. Remove water from sensor in order to
start back the unit.
Carry out the maintenance/change the filters
soon.
The electric/electronic system is not wor-
king properly /has failed*
PUSH LED
STATUS
MEANING
- Led is off - LED is permanently off LED is on: single flashing
LED is on: double flashing Acoustic signals Regular acoustic signals
x1
-
-
-
-
-
(*) Contact your service.
(**) In order to guarantee the quality of the produced
water, the unit will remain blocked after 1 year while
informing the user that the filters should be replaced.
If tou detect that the unit is blocked please contact the
maintenance service to make the appointment and so
do the maintenance required by the equipment.
(***) Contact your service if, after apening the faucet, the unit would find at rest without dispensing water
using the tap or showing any alarm.
Contact your service if the unit blocks repeatedly due
to low water pressure and having pressure water on
the rest of the house without dispensing water using
the tap or showing any alarm.
When you detect any of the states described above,
contact with the maintenance service to arrange appointment. See the relevant section in Technical
Manual.
The beeps are not continous; they last a few seconds
(10 s.) While maintenance state is maintained it will be
indicated by LED’s on the panel and acoustic notifica-
tion periodically every 7 hours.
Read troubleshooting section in User Manual.
x2
• The unit with a pump (PUMP) have a built-in low pressure
switch to protect the pump against pressure drops from the
network (LPS).
• Electronic system for leakage detection (L). When the sys-
tem detects this condition, it blocks the system and emits
an acoustic signal and a light signal to inform about the
situation. The unit will remain blocked until the leakage
sensor is dry.