14
Installation & Operation Manual
Copyright © Puretec Pty Ltd 2020
6. Turn the water off and purge the lines.
7. Plumb inlet and outlet pipe work to the Hybrid unit. Both the inlet and outlet are a
25 mm female brass connection.
Warning: Use PTFE thread seal tape on all connections. Use of pipe sealants
will void warranty.
8. Open the swing doors to the unit.
9. Remove the safety cap from the aluminium nut, if the nut is
inadvertently loosened during this process, retighten the nut.
Insert the spring into the ballast by dropping it into the chamber.
Slowly insert UV lamp into chamber through the hole of the
aluminium nut end. Connect the lamp connector to the pins on
the lamp. Do not let go of the lamp until the lamp is connected
to the socket (
see Fig. 8 & 9
).
Never touch the quartz (glass) and lamp surface as marks
or fingerprints may interfere with UV transmission. If lamp is
soiled, please clean lamp with an alcohol based cleaner.
10. Put safety cap on the aluminium nut. Connect the ground wire to the chamber. Plug
in power connector.
11. Check the main power cord for the unit is plugged in and the power is on.
12. Check each housing bowl and ensure they have not become loose in transport. Use
the provided spanner to tighten filter bowl until firm. DO NOT OVER TIGHTEN.
13.
(Pump Models Only)
Check the power cord for the pump is plugged in (power is
off).
14.
(Pump Models Only)
Ensure that water is reaching the pump, this may require
siphoning the line to begin water flow.
15.
(Pump Models Only)
Turn on the power to the pump.
16. Turn the water on, let the water flow through – opening a tap downstream to flush
the unit for 1-2 minutes. Then check the system thoroughly for leaks.
Note: For initial use, wait 3-5 minutes to allow water to pass through the whole
unit. Turn on a downstream tap to let water flow through the unit for 2-3 minutes to
release air and impurities from the system.
17. Turn the power to the UV system on and ensure that the lamp is operating. Make
sure that the GREEN LED is illuminated (refer Lamp Replacement Procedure on
pg.14).
18. Close and lock the swing doors. Note: Your cabinet comes with 2 keys for your
convenience. Please store them safely.
Note: Lost or misplaced keys are not covered by warranty.
Installation Procedure
1
2
valve
IN
OUT
10
mins
4
5
7
8
Replacing UV Lamp
valve
IN
3
Fig. 8
Lamp
Connector
Summary of Contents for HybridPlus P12
Page 28: ......
