2
THC1
for more information
01
Introduction
1
1
The THC1 set is designed for cutting height automatic control of CNC plasma cutting devices.
The set consists of two devices: control module THC1-M and voltage divider module THC1-DV1.
The both devices are powered by mains voltage ~220 V. It allows to install the divider module
in close proximity to plasma source and to preclude the use of any additional power supply
sources. The THC1-M measurement module is installed in the system CNC control cabinet.
The modules are connected using «twisted pair’ cable with 8P8C connectors.
THC1 set has been fully tested with plasma sources manufactured by Hypertherm company,
which are well-proven as reliable and high-quality equipment. Most of Hypertherm plasma
sources are equipped with special connectors for the THC units connection.
Make sure the following pre-requisites are met for correct operation of the other manufacturers
plasma cutters:
1. it allows to connect devices for automatic cutting height control;
2. the cutter electrical output parameters match the THC unit parameters. If the plasma
cutter manual does not provide the possibility of the THC unit connection, or plasma cutter
parameters do not meet the specified ones, the user is generally responsible for safe connection
and system operability.
• THC1-M controller – 1 pc.
• THC1-DV1 divider module – 1 pc.
• Ethernet cable – 1 pc.
Set of Delivery
2
2
02
