pureHeat GARAGE&PATIO, Owner'S Manual

Page: 10 / 16

10
UNIT SETUP - Wall/Ceiling Mount
1 . Ensure the desired mounting location can fit the unit in a horizontal orientation and is
near an outlet but free from electrical cables, communication lines, and pipes that
could be damaged by excessive heat.
2 . If needed, pre-drill your wall and insert
3 Wall Anchors. Use Bracket 2 as a
template for hole placement.
3 . Use Two (2) M6*14 Bolts and Two (2) Acorn
Nuts to combine Top of Bracket 1 (Long
End) to the Bottom of Bracket 2 (Short End) .
4 . Use Three Screws (Type will vary based
on your need) and fasten the Mounting
Bracket to the Wall in a vertical
orientation. Use the top hole and the
outside holes on the bottom.
5 . Use Two (2) M5*12 Screws to install the
Mounting Bracket to the rear of the
Heater Body.
FOR YOUR SAFETY, READ ALL IMPORTANT INSTRUCTIONS (PAGE 7) AND USAGE (PAGE 13)
BEFORE USING YOUR PUREHEAT PATIO.
x2
x2
HEATER MUST BE MOUNTED HORIZONTALLY OR THE TIP OVER SAFETY SWITCH WILL ENGAGE
AND THE UNIT WILL NOT OPERATE.
Mounting Sur
face