Altec AIR
P8400W Air-dryer User’s Guide
Page 7 of 110
P017585 – Rev. A
CAUTION!
Depressurizing the air-dryer may be necessary before performing
certain procedures.
NEVER
remove pressure sensing tubes from the
Control Board without depressurizing the air-dryer first, or
damage to
the Control Board will occur.
IMPORTANT!
Performing procedures not described in this User’s Guide or installing
components not supplied by PUREGAS is NOT RECOMMENDED
AND MAY VOID THE WARRANTY.
IMPORTANT!
Performing routine maintenance as outlined in the
Maintaining Your
Dryer
section will ensure optimal performance over the lifecycle of
your air-dryer.
CAUTION!
Incoming power to dryer must be 190 - 230 VAC
, 1 Phase, 50 / 60 Hz
with minimum 20 amp service (3-wire, nub-out receptacle) with a 20 amp
circuit breaker. If hard-wiring directly, minimum of 12 AWG wire must be
used with an External Surge Protection Device (SPD).
CAUTION!
Proper Installation & Maintenance as outlined in this User’s Guide is
extremely important to ensure the reliability and longevity of the
equipment as well as prevent damage or personal injury.
WARNING!
High Noise
. PUREGAS air-dryers are meant to be installed in an
unattended area.
Summary of Contents for Altec AIR P8400W
Page 1: ...P017585 Rev A P8400W Air dryer User s Guide...
Page 2: ......
