#4-40
SET
SCREW
SLIDING
POST
0.05"
ALLEN
WRENCH
1
1:
Loosen (
DO NOT REMOVE
) the two #4-40 set screws on
the sliding post with a 0.05" Allen wrench.
WARNING:
To avoid damaging the coaxial cable electrical
connection, make sure that the end of the coaxial cable coming
out of the fixture is held with thumb before relocating sliding
posts.
Section One: Adjusting Cable Position
A
#4-40
SET
SCREW
SLIDING
POST
0.05"
ALLEN
WRENCH
1
2:
Remove the sliding post from the channel. Carefully rotate
and move the sliding post to the predetermined location on
the channel.
B
C
3:
Place the sliding post back onto the channel and secure it by
tightening the two #4-40 set screws with the 0.05" Allen
wrench.
4:
Repeat Steps 1 through 3 for aircraft cables.
D
SAVE THESE INSTRUCTIONS!
- This product is suitable for indoor locations.
- This instruction shows a typical installation.
- It is recommended more than one person to assist in this
installation.
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-ZS-2SQ_01
Installation Instructions for
Zip Suspension Downlight with Remote
Power and 2" Square or Round Canopy
AIRCRAFT
CABLE
3
4
ZSD-2S_-__
ZSD-2R_-__
0.05"
ALLEN
WRENCH
#4-40
SET
SCREW
HOLD
CABLE
HERE
COAXIAL
CABLE
SLIDING POST
2
