2
Section Two: Install the Standoff
1:
Determine the fixture height (H) from the bottom of the
channel to the top of the canopy.
2:
Determine the fixture length (L). Measure the distance
between the coaxial cable and the aircraft cable on the
channel. Mark the standoff location on the ceiling from the
center of the junction box.
E
NOTE:
Run the proper size wires between the 24VDC power
supply to the electrical box. Refer to the instructions provided
with the power supply for additional information.
TOP VIEW
ANCHOR
ANCHOR MUST
BE FLUSH TO WALL
F
3:
Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4:
Screw in the threaded portion of the anchors with a Phillips
screwdriver.
CEILING
3
4
H
CHANNEL
CANOPY
STANDOFF
COAXIAL CABLE
AIRCRAFT
CABLE
L
STANDOFF
CANOPY
1
NOTE:
Omit steps 5 through 10 if using support canopy. Refer
to Section Three: Install the Support Canopy.
2
JUNCTION BOX
5:
Feed the #6 screw through the washer with threaded
nipple into the anchor.
6:
Tighten the #6 screw completely into the anchor.
7:
Tighten the standoff post completely onto the threaded
nipple.
G
#6 SCREW
WASHER
WITH
THREADED
NIPPLE
5
STANDOFF
POST
7
JBOX
8:
Feed the aircraft cable coming from the channel through the
standoff post.
9:
Adjust the fixture height by pushing the tab and pulling the
aircraft cable out of the side of the standoff post. Release
the tab to secure the cable in place.
10:
If necessary, trim excess aircraft cable using sharp cutters.
H
STANDOFF
POST
AIRCRAFT
CABLE
8
9
10
EXCESS
AIRCRAFT
CABLE
6
NOTE:
Omit Section Six if the channel is made out of a single
piece.
