+24VDC
+24VDC
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor locations.
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-SS5C-24V-2K4K_04
Installation Instructions for
SS5C Commercial LED Soft Strip,
Tunable White 2000K-4000K and SS10C Commercial LED
Soft Strip, Tunable White 2000K-4000K
SS5C-24V-_-2K4K
SS10C-24V-_-2K4K
Section One: Prepare the LED Soft Strip
A
LED SOFT STRIP
TRIM
LINE
1
UTILITY KNIFE
1:
If necessary trim the LED strip at the marked line above the
contact (every 2.4" apart) with a sharp scissor to fit the
design.
NOTE
:
Do not trim the strip over the sections that are joined
together by soldering. The soldered contact will not connect to
the Snap & Light connector easily.
NOTE
:
Do not trim the strip at unmarked sections which may
cause that section of the strip not to light up.
2:
Place the LED Soft Strip on a flat, stable surface. Using a
utility knife, carefully scrape the protective coating from the
contacts.
CONTACTS
2
1:
Align the +24VDC marking on the soft strip with the red wires of the Snap & Light connector. Insert the exposed contact at
the end of the LED strip under the Snap & Light contacts ensuring that the strip contacts are aligned and covered under the
connector contacts.
2:
Close the Snap & Light cover and ensure it snaps securely into place.
+24VDC
+24VDC
+
-
+
-
+
-
C
Section Two: Install the Soft Strip
LED SOFT
STRIP
SNAP &
LIGHT
CONNECTOR
EXPOSED
CONTACT
2
1
1
B
1
