04
05
PureAiro
DSC 120ES
Manual Drain Button
If you need to store or move your dehumidifier, press the “Drain” button to remove water
from the integral pump’s reservoir.
4
INDICATOR LIGHTS
Humidity Display Screen
The display screen has two functions:
1
2
Power Indicator Light
Continuous Mode/ Auto Defrost Light
This light indicates that the unit is properly powered on and ready to operate.
3
1. When the unit is powered on, it shows the humidity of the space
2. When setting the desired humidity level, the screen will show the set point.
Always make sure the unit is “off” prior to performing any service, unless otherwise
indicated.
If the humidity is above the setpoint, the light will be solid green and the machine will
operate.
After a brief delay, it will revert to current humidity of the space.
If the humidity is below the setpoint, the unit will be in standby mode and the light will be
flashing.
When the light illuminates green, it indicates that the dehumidifier is set to continuous
operation mode.
When the light illuminates red, it means the unit is in auto defrost mode and clearing the
evaporator coils of any ice buildup.
Compressor Light
4
When the light illuminates red, it indicates the compressor has been initiated but is
currently warming up.
Once the light switches to green, it means the compressor is currently in working status.
REMOTE CONTROL INSTRUCTIONS
PureAiro Dehumidifiers can be controlled using an optional remote accessory. The remote
connects to your dehumidifier via a 25’ CAT 5 cable, with the integrated sensor giving you
multiple options for monitoring surrounding conditions.
Example #1
- Install the dehumidifier in the laundry room and duct it into the living room.
Mount the remote in the living room and use the remote sensor.
Example #2
- Install the dehumidifier in your crawl space with the remote mounted in your
garage.
KEY FUNCTIONS
Power Key
Use this button to turn the dehumidifier on and off.
1
Press once to turn machine on. You will hear two beeps and the light will illuminate green
(solid or flashing depending on mode).
Press the power button a second time and you will hear one beep as the machine shuts
down. Note that there is a 1 minute fan delay.
Arrow Buttons
Use the up and down arrow buttons to set the desired humidity setpoint on the display
screen.
2
The setpoint can be any number between 36%-90%. When the indoor humidity is higher
than the setpoint, the unit will operate.
Press the power button a second time and you will hear one beep as the machine shuts
down. Note that there is a 1 minute fan delay.
Keep in mind that the displayed humidity levels are approximate ( +/-5%)
Continuous Mode
To set the unit to run continuously regardless of humidity, simply use the down arrow key
to set the humidity below 36%.
3
The continuous light will illuminate green and the display will show “CO”.
To switch back to normal humidistat operation, use the arrow keys to move the setpoint
above 36%.
