PURE STERIBASE 300, Operating Instructions Manual

Page: 7 / 28

Gebrauchsanweisung - 5/24
General information
Safety instructions
1) In Germany: VDE regulations
General safety instructions
– Unauthorized changes to the device are prohibited.
The manufacturer shall bear no liability for damage or
injuries resulting from such actions.
– The brackets are sealed to prevent unauthorized open-
ing. Brackets that do not have a seal or brackets with a
damaged seal may lead to a hazard to the user and to
the loss of the manufacturer’s guarantee.
– The device is only to be used if it is in perfect working
order!
– No safety equipment (e.g. stickers, seals, protective
covers or other components/attached parts) may be
removed or deactivated if this could impair the safe op-
eration of the device!
– If it is obvious that the device is damaged, it must not
be put into operation!
– Air intake and air outlet openings should not be cov-
ered!
DANGER!
Personal danger due to electric shock or
burns!
Assembly and electrical connection must comply
with the national regulations.
1)
The upgrading, maintenance or repair of the de-
vice may only be carried out by specially trained
and instructed personnel.
– Disconnect the device from the power supply
before performing any work.
DANGER!
Risk of eye and skin damage due to UV-C ra-
diation!
Even when radiation periods are short, UV-C ra-
diation can severely damage the skin and, par-
ticularly, the eyes! Direct irradiation of eyes and
skin must be strictly avoided.
– Disconnect the device from the power supply
before carrying out any maintenance work
and before opening the device.
– Never operate UV-C lamps outside the device
or when it is open!
DANGER!
Risk of eye and skin damage due to UV-C ra-
diation!
Connection to the mains can be made before as
well as after installation. It is imperative that the
power supply is switched off during assembly so
that the device cannot be turned on by mistake
and UV-C radiation cannot escape.
– Switch off the power supply before assembly
and back on only after the assembly work has
been fully completed.
DANGER!
Danger to persons due to maintenance work
not carried out!
If the maintenance work is not carried out, mate-
rial damage and personal injury may occur!
– Maintenance work may only be carried out by
persons who have been authorised, trained
and qualified by JK-International GmbH, JK-
Global Service department!
– The operator is responsible for compliance
with the maintenance intervals!
CAUTION!
To protect the device from unauthorised opening
and to secure the guarantee claims, all brackets
must be sealed!
CAUTION!
Using unsuitable lamps can eliminate the
effectiveness of the device and void the
CE
conformity !
– Use genuine UV-C lamps only.
CAUTION!
Risk of damage to the device!
UV-C lamps are sensitive components and may
be easily damaged.
– Do not touch the lamps with bare hands.
Wear protective gloves.
– Take care when touching and installing the
lamps. Do not bend. Do not rest on the pins.
CAUTION!
Only use genuine spare parts of the same type!
Using other spare parts can eliminate the
effectiveness of the device and void the
CE con-
formity !
Any liability is excluded in case of damage or
injury proven to be the result of the use of non-
genuine spare parts.