Gebrauchsanweisung - 20/24
Installation and operation
Operation
Overview of the control panel
Switching the fan on
You can select one of the three ventilation levels using the
buttons
and
.
Switching the fan off
You can select level
0
using the buttons
and
.
Switching the sound on and off
Press and hold buttons
and
at the same time for
around 3 seconds.
The sound is switched on or off.
Faults
A fault is indicated by a red LED on the control panel.
– Switch the device off.
– Rectify the fault if possible (e.g., clean the filter, clear
any covered openings, check the mains plug and On/
Off switch).
– Switch the device on.
If the red LED continues to light up, please call Cus-
tomer Service.
0
UV-C lamps and fans are switched off
AUTO
Not currently used.
I - III
UV-C lamps and fans are switched on
(Ventilation levels I to III)
Red LED
You can change between the individual functions using
the buttons
and
.
Note:
When the signal tone is switched off, any mal-
functions of the device are only indicated by a
red LED.
Note:
If the mains plug has been pulled out and insert-
ed again, the button tones are switched on.
Summary of Contents for STERIBASE 300
Page 1: ...Operating instructions EC Declaration of Conformity pure STERIBASE 300...
Page 2: ......
Page 27: ......
