4
13
USE AND CARE OF THE DRINKING
WATER CONTAINER
To ensure proper performance and a lifetime of trouble-free
service, please read the following information on general use
and care of the drinking water container:
• Do not use on stove-top burner, under heating elements, in
microwave or conventional ovens.
• Do not store hot liquids nor food in drinking water container.
• Freezer-safe.
• Do not place base in dishwasher.
Lid
: Dishwasher safe, top
rack only.
• Do not use abrasive cleaners or sharp utensils.
ELECTRICAL REQUIREMENTS
The Pure Water Mini-Classic must be plugged directly into a
fully grounded outlet.
The Pure Water Mini-Classic will use approximately 8 amps
when operating, so isolate a 10 amp fuse or circuit breaker for
the unit.
This unit operates on 110V, 60 cycles, or as otherwise specified
on the back of the distiller.
THE USE OF EXTENSION CORDS
An extension cord is not recommended. However, an extension
cord may be used if care is exercised.
If an extension cord is used:
a. The marked electrical rating of the extension cord should
exceed the electrical rating of the Pure Water Mini-Classic
(see the specifications on back of the unit).
b. The extension cord must be a three-pin grounded type.
c.
The extension cord should not be placed under carpet or left
where persons may trip over it.
d. Do not overload extension cord with other power consumers.
ORDERING PARTS & SERVICING
Pure Water recommends that you have your Pure Water Mini-
Classic serviced by an authorized service center. Please see your
Pure Water Dealer or Distributor.
If you require parts or accessories at any time, please contact
your Pure Water Dealer or Distributor. In the unlikely event your
Pure Water Dealer or Distributor cannot help, you may contact
Pure Water, Inc. Customer Service at 800-875-5915.
To help you identify parts for your Pure Water Mini-Classic
please see the parts list included in this manual on page 14.
SYMPTOM
SYMPTOM
SYMPTOM
SYMPTOM
SYMPTOM: There is steam around the unit...
Possible Cause
Check...
... that the unit is not pushed hard against
the wall. Keep about 1 inch clearance.
... if there are any items on the unit that
may block the air flow. Remove any such
items.
Possible Cause
Check...
... if the fan is not turning and you have
checked that there is power to the unit,
and the power switch is on, then it may
be a failed fan motor. Replace the fan
motor (stock
#
45517).
INSUFFICIENT
VENTILATION
OF THE UNIT
FAN MOTOR
SYMPTOM
SYMPTOM
SYMPTOM
SYMPTOM
SYMPTOM: There is water around the unit...
Possible Cause
Check...
... that the carbon filter is in proper position
and water is flowing through it.
... that the drinking water container is
correctly placed to catch the water.
IMPROPER
POSITIONING
