UNPACKING AND OPERATING INSTRUCTIONS
To operate your AirMac-750E Air Cleaner properly, it is necessary to remove plastic
packing material from the carbon after-filter inside the unit. Follow the step–by–step
instructions and you will soon be enjoying clean fresh air!
1. Remove the two fasteners and the variable speed control knob from the top of the
cabinet.
2. Lift the cover assembly from the chassis and set aside.
3. Remove the carbon after-filter from behind the cell. Take off the protective packing
material and discard.
4. Replace the carbon after filter, then the cover assembly, making sure to include
both fasteners and the variable speed control knob.
NOTE: The fasteners must be in place and secured snugly or the unit will not
operate.
5. Place your AirMac-750E Air Cleaner in a convenient area in the desired room. If you
are using the air cleaner for a specific purpose, such as smoke removal, locate the air
cleaner as close as possible to the source. (Such as near a smoking stand.) Care
should be taken to allow at least 4-6” of unobstructed space behind the unit so that it
will Exhaust freely into the room. If, however, you position the unit so that the
airflow is parallel to the nearest wall, you need not to allow as much free space. For
best results the unit should be elevated by placing it on a table or stand. It can also
be mounted on a wall, using our convenient wall mount option.
6. Plug the line cord into a standard household outlet with 120V AC 60 Hz (230 models
require 230 V AC 50 Hz). Caution should be taken to use the unit only on the
required voltage, as to do otherwise will void the warranty.
OPERATING INSTRUCTIONS
Position the unit and plug it into the proper line voltage before turning it on.
To turn unit on, locate the variable speed control on top of the unit. Under normal
conditions, the Low position is adequate to keep an average size room clean. With
excessive amounts of dust, smoke, or other pollutants present, the air cleaner should be
operated on high.
NOTE: It should be noted that occasionally, a large particle will pass through the electronic cell and an
arcing will occur, resulting in an audible cracking sound. This is normal and will not cause any damage to the
unit.
Pure n Natural Systems, Inc. | https://purennatural.com | 1-800-237-9199
