ASSEMBLY AND INITIAL SET-UP
For your safety and convenience, the Pure Fitness
™
Mini-Stepper has a factory welded frame and
ships to you pre-assembled. To complete the assembly of your Stepper follow the simple steps out-
lined below.
1.
Fit the Step Arm Height Adjustment Knob (18) into the hole in the front of the Main Frame and turn
it Clockwise “+” until you feel some resistance. DO NOT fully tighten this knob.
2.
Remove the Battery Compartment Cover from the rear of the Exercise Monitor. Place the batteries
into the Battery Compartment, and replace the Battery Compartment Cover.
3.
Connect the Exercise Monitor Sensor Wire (30) into the connector input on the rear of the Exercise
Monitor.
4.
Slide the assembled Monitor onto the Exercise Monitor Mount.
5.
Adjust the Step Height on your Mini Stepper. For initial set-up, a step height of approximately 6”
is advisable. To do this, use one hand to push down on one Step Arm Footplate (26), so it is fully
depressed. While holding this step down, turn the Step Arm Height Adjustment Knob in a Clockwise
“+” direction, allowing the other Step Arm Footplate to rise, until it is at a height of approximately 6”
above the rear stabilzer.
6.
Attach Stretch Cords to the Main Frame by clipping the Stretch Cord hooks to the 2 welded
attachment loops on the front stabilizer bar.
RESISTANCE AND STEP HEIGHT ADJUSTMENT
The Hydraulic Cylinders on your Mini-Stepper are single acting, and their resistance levels have been
configured and set in the production process.
To intensify your workout, increase the height of the pedals by turning the Step Arm Height Adjust-
ment Knob in a Clockwise “+” direction.
To decrease the intensity of your workout, decrease the height of the pedals by turning the Step Arm
Height Adjustment Knob in a Counter-clockwise “-” direction.
