customerservice
@
puregbi.com
1-866-498-5269
MODEL# 8650IT - PAGE 9
ASSEMBLY INSTRUCTIONS
STEP 1:
A.
Take out the Pre-assembled Front and Rear Base A-Frame (1
and 2). Extend the Frame legs so the A-Frame is fully opened.
Make sure the center bars (11L & 11R) are pushed down and
completely extended.
NOTE:
Make sure to attach Part 4 as shown, with the ends pointing
towards the ground and the grooved sections resting securely in
the A-Frame. Make sure that connect sheet is attached inside
the A-Frame. If you are uncertain which adjustment hole in the
Connect Sheet to use, you can start with the center hole and adjust
later if necessary.
B.
Attach 2x Connect Sheets (4) to the Backrest
Support Frame (3) as shown. Make sure the Connect Sheets are
securely affixed in their housings on the Backrest Support Frame.
Place 2x M6x10 Screws (17) and 2x M6 Lock Nuts (21) at the hole
in the bottom of the Connect Sheet. This will help ensure the Sheet
does not slide through its housing in case of accidental dislodging.
C.
Using the slotted round tops of the attached
Connect Sheets, insert the Backrest Support Frame into the
cradles on top of the A-Frame. Once attached, Secure the Connect
Sheets to the Support Frame with 2x Small Lock Pins (5).
STEP 2:
A.
Using 1x M10x35 (13) Hexagonal Bolt and 1x M10x30 (14)
Hexagonal Bolt, attach the Left Handlebar (6L) to the hole in the
Rear Base Frame (2).
B.
Place the Left Cap Bag (26L) on the Left side of the Base Frame
before continuing. Do not secure the Velcro attachment yet.
C.
Next, attach the curved Position Metal Sheet (12) to the end of
the first Hexagonal Bolt (13) making sure the Connect Sheet (4)
is in the middle. Secure the Hexagonal Bolts (13 &14) with 4 flat
washers (15) and 4 M10 Lock Nuts (16) as shown.
Follow the above instructions to attach the Right Handlebar (6R)
and Right Cap Bag (26R).
D.
If open, close the Position Metal Sheets (12) so they rest against
the A-Frame, securing Part 4 in place.
E.
IMPORTANT: Attach 2x Hex Bolts M6*10 (17) onto each side
of the base frame after attaching and closing the Position Metal
Sheet (12) on the Base frame. This assembly will prevent the
Backrest Support Frame (3) from slipping out of the housing
during use.
1
14
13
6R
6L
17
17
12
13
14
12
15
11R
11L
2
21
4
4
21
17
17
3
5
5
16
