19-00134_MTS40-240_Standard_Installation_Manual_082819_Rev3.Docx
Page 20 of 25
MTS Filter Element Service Requirements
WARNING:
UNIT IS HOT
USE CAUTION
Lid Removal, Filter Element
Replacement and Lid Reinstall
1. Engine must be
shutoff
and time allowed for
the oil to drain from using before changing the
filter element.
2. Loosen the four nuts on the retaining studs,
enough to allow the studs to swing clear of
HEAD (lid).
3. Remove the HEAD (lid) from MTS Unit.
Inspect flat gasket inside HEAD. Gasket
should regularly be replaced.
Note
: The
Canister and HEAD can be
HOT!!!
4. Remove the filter by firmly pulling up on the
wire handle.
Note: Be sure to save the new
filter plastic bag, and reuse for spent filter
in order to prevent oil spills.
5. Insert the new filter into the Unit, making sure
the rubber grommet at the bottom fits securely
over the nipple in the bottom of the Unit
canister.
6. Install new Flat Gasket into HEAD, if
applicable.
Refer to serviceable parts manual
for gasket part number.
7. Place the HEAD (lid) on the MTS Unit (making
sure the flat gasket on the underside of the
HEAD is securely in place).
8. Rotate the four studs into position to tighten.
9. Tighten the nuts securely (5
–8 ft-lbs./torque)
using a diagonal (star) pattern as indicated on
the Lid.
Head
Retaining Stud &
Bolt Assembly
Flat Gasket
Filter
Unit Canister
