1 0 |
P a g e
At any point during this sequence, the audible chirp or alarm can be deferred for seven
days by holding the controller button down for a period of five seconds. The number of
deferrals used will be displayed as below. Once the deferral expires, the alarm will sound
once again. The deferral can be repeated up to three times.
PLEASE NOTE:
At any point
after lamp expiration, the water disinfection rate is now compromised.
LAMP REPLACEMENT
After the lamp is expired, it must be replaced with the same part number as indicated
by the label on the chamber. Begin replacing the lamp by unplugging the power for the
controller, then refer to step 8 from the installation section of the manual (page 6) for
instructions on installing the new lamp. To reset the timer in the controller, firmly hold
down the button on the controller for 10 seconds. The controller will read “rSt3”, “rSt2”,
“rSt1” and then beep. The button can now be released, the lamp countdown timer has
been reset.
SYSTEM TROUBLESHOOTING
Hard Alarms
: The following give a constant audible alarm.
System Display
Problem
Resolution
The system has detected a
problem with the lamp.
Reset lamp protection circuit
-unplug unit for 10 seconds.
Replace the lamp with the part as
indicated on the silver label on the
chamber or on the Maintenance
parts screen.
Although the lamp is
powered and visibly
illuminated, due to the
lamp’s age its UV output
is no longer sufficient for
proper disinfection.
Replace the lamp with the part as
indicated on the silver label on the
chamber or on the Maintenance
parts screen.
For any other questions or troubleshooting, please contact your dealer or reach out to us
at 1-855-881-0889 or [email protected]