www.pulsar.pl POE1648C
6
Diagram 1. Maximum permissible output current depending on ambient temperature.
2. Installation.
2.1. Requirements.
The buffer PSU should be mounted by a qualified installer, holding relevant permits and licenses (applicable
and required for a given country) for 230V/AC and low-voltage installations. The unit should be mounted in
confined spaces, in accordance with the 2nd environmental class, with normal relative humidity (RH=90%
maximum, no condensation) and temperature range from -
10°C up to +40°C. The power supply should operate in a
vertical position in order to provide free and convectional air flow through ventilating holes of the enclosure.
During normal operation, the total current drawn by the device should not exceed I=16x0,3A
*
.
Maximum battery charging current is 0,5A. Total current of the receivers + battery is max 5A*.
The power supply is designed for a continuous operation and is not equipped with a power-switch.
Therefore, an appropriate overload protection in the power supply circuit should be provided. Moreover, the user should
be informed how to disconnect the power supply unit from the mains supply (usually by assigning an appropriate fuse in
the fuse box). The electrical system shall be made in accordance with applicable standards and regulations.
The PSU is designed for 10Mbit/s and 100Mbit/s Ethernet network (so-called Fast Ethernet)
. However, it can
not be used for a 1000 Mbit/s network (so-called Gigabit Ethernet).
Connections between the power supply and the
camera can be done using UTP-3 cable (networks with data-rates up to 10 Mbit/s) or UTP-5 cable. Due to the lower
resistance wiring, it is recommended (especially at large distances between the power supply and receivers) to use UTP-
5 cable also for networks with data-rates up to 10 Mbit/s.
2.2. Installation procedure.
1. Before installation, cut off the voltage in the 230V power-supply circuit.
2. Mount the PSU in a selected location and lead the connecting cables.
3. Connect the power cables (230V AC) to L-N terminals of the PSU. Connect the ground wire to the terminal marked
with grounding symbol:
. Use a three-core cable (with a yellow and green PE protection wire) to make the connection.
The power cables should be connected to the appropriate terminals on the connection board through the bushing.
The shock protection circuit shall be done with a particular care: the yellow and green wire
coat of the power cable should be connected to the terminal marked with the
symbol
in the PSU enclosure. Operation of the PSU without the properly made and fully operational
shock protection circuit is UNACCEPTABLE! It can cause damage to the equipment or an
electric shock
.
4. Connect the network cables (Ethernet) to the PoE module: supply voltage is present only at the POE sockets and the
cameras should be connected to them. Pin assignment of the LAN and POE sockets is shown in the Figure 4:
*
See diagram 1