Pulsar PG4500BiSRCO, Operator'S Manual

Page: 12 / 25

12
• Place generator on a firm level surface.
• Unclip and remove the oil service panel to access
the oil fill/dipstick.
CAUTION!
ASSEMBLY
•
•
Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of engine oil (SAE 10W-30) to
empty reservoir until or oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
Be sure to replace dipstick and tighten securely before attempting to start the engine.
• To check oil, set generator on a firm level surface, unscrew and remove dipstick, wipe dipstick clean,
then reinsert dipstick without re-threading.
• Remove the crankcase dipstick.
Recommended Oil: SAE 10W-30
Oil Capacity: 0.6L (20.2oz)
Checking/Adding Engine Oil
Generator has been shipped without engine oil. You must add engine oil before operating this
generator. Always check oil level before each operation.
Battery Installation
1. Loosen four Phillips screws, but do not remove them
from the side panel.
2.. Carefully lift all four edges of the side panel, releas
the clip; then lift it away.
3.. Insert battery into the holder until it clicks firmly in pla
4.. Carefully line up the side panel and press the ed
until the side panel is completely flush and evenly
installed.
5.. Tighten all four Phillips scre
NOTE: This generator is equipped with a battery charging feature. When the engine is running,
a small charge is supplied to the battery.
1
Side Panel
Battery