Visit:
www.tester.co.uk /
Call:
01642 931 329
TECHNICAL INSPECTION
22
Check:
External view (there should be no cracks on the housing).
The state of the objective and eyepiece lenses (there should be no
cracks, spot, dust, deposits etc. ).
The state of the Battery Pack (should be charged) and electric
terminals (there should be no oxidation).
Correct functioning of the controls.
TROUBLESHOOTING
2
4
The table presented below lists some potential problems that may occur
when using the device. If a problem encountered with the device is not
listed, or if the recommended action does not resolve the problem, the
unit should be returned for repair.
2
3
MAINTENANCE AND STORAGE
Maintenance should be carried out no less frequently than twice a
year, and should consist of the following measures:
Wipe external plastic and metal surfaces clean of dust and dirt with
a soft cloth moistened with a synthetic cleaning agent.
Clean the electric terminals of the Battery Pack and device's
battery slot using a grease-free organic solvent.
Check the objective and eyepiece lenses. If required, remove dust
and sand (preferably by a noncontact method). Clean the external
surfaces of the lenses with products expressly designed for this
purpose.
Store the device in a carrying case. Remove the Battery Pack
for long-term storage.
The thermal imager
will not turn on.
The unit does not
operate on external
power supply.
Battery Pack is discharged.
USB cable is damaged.
Charge the battery.
Replace USB cable.
Check
Corrective action
Problem
External power supply is
discharged.
Charge the external power
supply (if necessary).
23
24
Connection modes:
Memory card (external memory).
In this mode the device is
detected by the computer as a flash card. This mode is designed for
work with the files saved in device's memory. The device's functions
are not available in this mode; the device turns off automatically.
- If video recording was in progress when connection was made,
recording stops and video is saved.
When
USB
is disconnected from the device where connection is in
the
USB
Mass storage device mode, the device remains on the
OFF
state. Turn the device
ON
for further operation.
Power.
In this mode PC/laptop is used as an external power supply. The
status bar shows icon . The device continues operating and all
functions are available.
Note:
The Battery pack installed in the device is not being charged!
When
USB
is disconnected from the device when in the Power mode,
the device keeps operating with Battery Pack, if available, and it has
sufficient charge.
WIRELESS REMOTE CONTROL
(bought separately)
21
Wireless remote control (RC) duplicates the
POWER ON
function, digital
zoom, video start/stop and menu navigation.
RC controls are as follows:
ON Button (15)
: duplicates the functions of the
ON (11)
button.
Button (16)
: digital zoom activation. Function
PiP
.
Button (17)
: duplicates the functions of the
REC (7)
button.
Controller
(18)
: duplicates the functions of
the
М
(9)
button when pressed; duplicates
the functions of the
UP (10)
/
DOWN (8)
upon rotation (in quick menu/main menu).
15 16
17
18
