ENGLISH
Attention!
When the SumLight™ function is activated, the noise level in the
image increases, the frame rate decreases and the image slows down. Any
sharp movement of the device may cause the image to become “blurred”.
Such effects are not defects. Luminous white dots (pixels) may be visible on
the device’s display. The number of dots may increase when the SumLight™
function is enabled. This is due to the peculiarities of this function and is also
not a defect.
Display Calibration
The attachment is configured so that after fitting onto an optical riflescope that
had been properly zeroed, no adjustment of the aiming point is required. Yet if
point of impact change is observed after putting on the attachment, you can fix
it with display calibration procedure.
•
To enter display calibration mode,
first press and hold the
M (7)
button for 10 seconds.
•
The display coordinates X=0; Y=0
will appear.
•
Use the
LEFT
(8)
and
RIGHT
(6)
buttons to move the display
horizontally (X axis) and vertically
(Y axis) so that the point of
impact moves to the center of the
riflescope reticle.
•
Press the
M (7)
button to toggle
between the X and Y coordinates.
•
The image offset range is +/- 20 pixels horizontally (X axis), +/- 20 pixels
vertically (Y axis).
•
To exit the menu and save the settings, press and hold the
M (7)
button for
two seconds.
Riflescope reticle
Display displacement
Impact point
Display coordinates
8
