www.pulsar.pl EN54C-LCD
RED POWER plus
2
GENERAL SAFETY RULES
Before installation, read the instruction manual to avoid errors that
can damage the device and give you an electric shock.
Before installation, cut off the voltage in the 230 V power-supply circuit.
To switch power off, use an external switch, in which the distance between the contacts
of all poles in the disconnection state is not less than 3mm.
The shock protection circuit shall be done with a particular care: the yellow and green
wire coat of the power cable should be connected to the terminal marked with the
grounding symbol on the PSU enclosure. Operation of the PSU without the properly
made and fully operational shock protection circuit is UNACCEPTABLE! It can cause
damage to the equipment or an electric shock.
Removed batteries should be stored in a designated collection point. Do not reverse
polarity of batteries. Explosion hazard if a battery has been replaced by an incorrect type.
Device should be transported without batteries. This has a direct impact on safety of user
and device.
Installing and connecting the power supply must be carried out without batteries.
When connecting batteries to the power supply, pay particular attention to the correct
polarity. If necessary, it is possible to permanently disconnect the battery from the power
supply systems by removing the F
BAT
fuse.
The power supply is adapted to be connected to a power distribution network with an
effectively earthed neutral conductor.
Ensure a free, convection air flow around the enclosure. Do not cover the ventilation
openings.