Page
75
P929 Site Identification
This parameter allows you to give each unit an individual reference number,
for identification purposes. You can set any number between 1 and 99999.
P930 Factory Defaults
This parameter resets all parameter values to the original Factory Set values
that were installed when the unit was tested, before despatch to you.
To
reset
parameters, enter
1
(
Yes
), and press
ENTER
, then you will see a
message “
Entr if sure
”, you should press
ENTER
again. If you press any other
key at this point, the parameters will not be reset, and you will see a message
confirming this.
Once you have done this, program the unit, to the desired application.
Date & Time
The date and time is used, to control specific relay functions and date stamp
certain events that are contained in the Data Logs.
P931 Date
This parameter shows the
current date
, in the format as set by
P933
(
Date
Format
), and can be reset if required.
P932 Time
This parameter shows the
current time
and can be reset if required, in the
format HH: MM (24-hour format). This is set initially at the factory for UK
time.
P933 Date Format
This parameter allows you to alter the format that the date is displayed to your
choice of DD: MM: YY, MM: DD: YY or YY: MM: DD. The default is MM:
DD: YY.
