6
7
Connect the external power supply to the USB port
(15)
of the device
(Pic. 1
on the flyleaf
)
.
The device can be powered with an external power supply such as
Power Bank (5V).
If the device operates on external power supply but the IPS7 battery is
not connected, the icon is shown.
The device switches to operation from external power supply, and the
IPS7 Battery Pack will begin slowly charging.
The display will show the battery icon with charge level as a
percentage.
When the external power supply is disconnected, the device switches
to the internal battery pack without powering off.
WARNING! The radiator cooling system (12) becomes warm during
operation: this is normal and allows an increase in the sensitivity of
the device.
WARNING! Do not point the objective lens of the device at intensive
sources of light such device emitting laser radiation or the sun. This
may render the electronic components inoperative. The warranty
does not cover damage caused by improper operation.
8
Powering on and image setup
Open the lens cover
.
(13)
T
device
ON/OFF
(1)
urn the
on with a short press of the
button.
Adjust the interpupillary distance with the rings
(6)
by moving the
eyepieces farther or closer to each other.
ring
.
(8)
To set up display brightness and contrast and continuous zoom,
please refer to the
MENU FUNCTIONS section.
QUICK
A
press and
ON/OFF
device
fter use,
hold down the
button to turn the
off.
To focus on the object being observed rotate the lens focusing
To obtain a crisp image of the icons on the display, rotate the dioptre
adjustment ring
.
there is no need to rotate the
s
(7)
Once adjusted,
dioptre adjustment ring for distance or any other conditions.
Never use a modified or damaged charger.
Do not leave the Battery Pack with a charger connected to the
mains longer than 24 hours after full charge.
Do not expose the battery pack to high temperature or to a naked
flame.
When using the battery at negative temperatures, battery's capacity
decreases, this is normal and is not a defect.
Do not connect external device with a current consumption that
exceeds permitted levels.
Keep the battery out of the reach of children.
Do not use the battery at the temperatures above those shown in
the table – this may decrease battery's life.
Do not submerge the battery in water.
The Battery Pack is short circuit protected. However, any situation
that may cause short-circuiting should be avoided.
Do not drop or hit the battery.
Do not dismantle or deform the Battery Pack.
Calibration allows levelling of the background temperature of the
microbolometer and eliminates image flaws (such as frozen image,
vertical stripes etc.).
There are three calibration modes:
manual
(M)
, semi-automatic
(SA)
and automatic
(А)
.
EXTERNAL POWER SUPPLY
OPERATION
SENSOR CALIBRATION
8
7