14
2.09.21.RH.rev A
MOUNTING POST ADJUSTMENT
If the OE Series SuperGlide is loose on the mounting
washer or the mounting post will not rotate while seated in
the Puck, the Mounting Post is in need of adjustment. To
adjust the Mounting Post, perform the following:
1. Remove the Cotter Pin from the Mounting Post
Assembly.
2. Rotate the castle nut open until it is near the handle
and then insert the assembly through the opening in
the hitch base into the puck and rotate the handle to
the closed position.
3. Next, lift up on the handle so that the top of the cross
pin touches the bottom of the puck.Thread the nut
down until it bottoms out against the hitch base.
4. Rotate the handle open and closed to test the
tightness “feel”, if the handle rotates with too much
difficulty, then back off the castle nut one crenal and
try it again. Likewise, if the handle rotation is too
easy rotate the castle nut one additional crenal. Keep
repeating this action until you have a snug fit.
5.
Once you have a snug fit, remove the post assembly
and insert the cotter pin. Bend the end of the cotter pin
to secure the nut in the chosen position.
6.
Re-latch the Mounting Handles as shown on the first
page of Mounting Post Installation (Page 13).
NOTE:
The Castle Nuts may require additional
adjustment (tighter) after hitching for the first
time and the hitch settles down on the Mounting
Assembly.
COTTER PIN
CASTLE NUT
CRENAL
COTTER
PIN HOLE
