NORMI 13 (T42023)
Operating Manual - Accessories
D703.131.00/03 en
29
4.2
Use of the Wall Stand Holder T20018 with Bucky Mounting
Device T20005 and Test Object
Assembly
•
Place the wall stand holder T20018, the test
object, and the bucky mounting device T20005
on a suitable table.
•
Fasten the rails of the wall stand holder
T20018 to the bucky mounting device T20005
(refer to
).
•
Set the angle bracket for fitting the bucky
mounting device to the thickness of the wall
bucky.
•
Insert the test object in the wall stand holder.
Using the set screws (
3
,
), press the
test object against the rails.
HINT
For further use, please remember that the test
object and the holder are
not
firmly joined.
•
Using a ruler or the edge of the table, align the
height of the test object in the mounted holder.
•
Holding the assembled holder with both
hands, suspend it in the wall bucky. It may
prove necessary to adjust the position of the
bucky mounting device.
Disassembly
•
Holding the assembled holder with both
hands, lift it off the wall bucky. To further disas-
semble the holder, place it on a suitable table.
•
Undo the set screws (
3
) and remove
the test object.
