PX 300
Page 9
Build the Sponsons Con’t
Sponson Sheeting
Non Trip
Step 6
A:
Start with your Sure Form if you bought one, if not a sanding block will work fine, sand the outer edge surfaces flush
with the former as shown. Once its close, use a sanding block to finish, work length wise down the sponson so the edg-
es are uniform
B:
Using a straight edge lay it across the former to be sure the sheeting lays flat on the former, outer edge sheeting and
the former. NOTE you will see a slight bevel on the sheeting and the former as shown
C:
Locate Sponson “Non Trip” from
SHEETING SHEET 2
D:
Test fit sheet as shown making sure the sheet is flush or has some over hang. BE SURE TO LEAVE 1/8” See the
picture on the next page
E:
Glue into place, Using masking tape to hold in place, clamp to the building board while the glue dries to prevent
twists in the sponsons
NOTE: BE SURE to use plenty of masking tape, its very important the sheeting is flash with all the stingers and bulk
heads.
A
Note bevel
B
D
Masking tape omitted
for clarity