Step 1
Center Section
Join the Center Section
A:
After the glue is cured, remove tape and clamps Sand the center section flush, unlike these pictures we recommend
sanding BEFORE you install the dowels
B:
Make sure the center section is square to the building table as shown. Take extra time on this step, if this is flush
and square your sponson will be straight and perpendicular to the center section
C:
Glue the dowels in place
D:
Test fit the sponons, by clamping are shown then check the perpendicularity to the center section
E:
Check to be sure the spnsons are flat on your building table
A
B
C
D
D
E
PX 300
Page 30