WARNING: Laser radiation - avoid direct eye exposure! This item is not for
children under 14. Misuse of the device can result in permanent eye damage.
Note: Class IIIA laser product, less than 3.5mW power output and accuracy to
+/-2 mm at 10 m and 25 m. Not suitable for outdoor use and laser may need a
simple adjustment to plumb level before first use. Handle with care and don't drop
from heights to avoid damaging the glass indicators.
1. Locate the battery compartment (3) near the power switch (2).
2. Remove securing screw with a PH0 Phillips head screw driver.
3. Open compartment and insert 3 new LR44 / AG13 button cell batteries paying
attention to polarity.
Note: Negative contact is indicated inside compartment and positive side of battery
goes towards spring.
4. Replace battery cover and turn screw until snug. Overtightening may cause
damage to door or strip screw.
1
TOOL FEATURES
Weight ............................................................................................... 8 oz.
Dimensions ................................................................... 7.3 X 1.1 X 2.5 in.
Batteries ..............................................3 LR44 Alkaline batteries included
Laser.....................................................Class IIIA, >3.5mW Power output
Accuracy ..........................................................+/-2 mm at 10 m and 25 m
TECHNICAL SPECIFICATIONS:
1. Laser Head
2. Laser Power Switch
3. Battery Compartment
4. SAE Ruled Straight Edge
5. 8 ft. (2.5 m) Tape Measure
6. Tape Measure Lock Release
2
5
1
7. Vertical Bubble Level
8. Horizontal Bubble Level
9. 45° Bubble Level
10. Metric Ruled Straight Edge
Technical specifications are subject to change without notice.
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or maintain
this product. Failure to comply with the instructions may result in serious personal injury and/or property damage!
3
4
7
8
9
Measures, levels and projects a laser line with 3 different patterns and is ideal
where a straight line or accurate measurement is needed.
Note: Class IIIA laser product, less than 3.5mW power output and accuracy to
+/-2 mm at 10 m and 25 m. Not suitable for outdoor use and laser may need a
simple adjustment to plumb level before first use.
SAFETY PRECAUTIONS
BATTERY INSTALLATION
Move laser head to the top position
to project a horizontal line.
Move laser head to the middle
position to project a cross beam.
Move laser head to the bottom
position to project a vertical line.
OPERATION INSTRUCTIONS
LASER CALIBRATION:
1. Before putting into use verify the true accuracy of the horizontal laser line.
2. Place the 4-in-1 Laser Pro onto a level surface.
3. Adjust the laser head (1) to the cross setting (Fig. 1)
and project laser onto a wall approx. 5 - 10 ft. away.
4. Use a ruler to verify the left and right sides of the laser line
are equal distances from the floor. This step verifies
accuracy of the horizontal line.
5. If needed the angle of the projected laser line can be
adjusted by turning the head of the laser (1) using
a straight edge or large screwdriver (Fig 2).
Note: Be careful not to scratch or damage the laser lens
during the laser adjustment process.
LASER OPERATION:
1. Point laser towards the intended surface and away from
your or other’s eyes.
2. Turn laser power switch (2) from O to I to power “ON”.
3. Adjust Laser Head (1) to the preferred pattern by moving
the head to the top, middle or bottom position as shown below.
Note: The laser will stay on until you turn power switch (2) to
the off position.
Move the laser head to
the middle position to
project a cross beam.
Fig. 1
Fig. 2
6
