PT CPC5565, User Manual, Page: 72 / 118

Chapter 4: System Monitoring and Alarms
72
Serial Line Properties Commands
The SIPL provides commands to get/set the properties of the IPMC serial interfaces (the serial
debug interface and the payload interface):
• “Get Serial Interface Properties Command,” on page 72
• “Set Serial Interface Properties Command,” on page 72
Get Serial Interface Properties Command
The Get Serial Interface Properties command is used to get the properties of a particular
serial interface. This command has the following synopsis:
[B8 xx 01 0A 40 00 <interface ID> ]
The
<interface ID>
parameter can have one of the values shown in Table 4-7, “The
<interface ID> Parameter Values,” below.
The IPMC responds to the Get Serial Interface Properties command with the following reply:
[BC xx 01 00 0A 40 00 <interface properties> ]
The
<interface properties>
parameter has the bit fields shown in Table 4-8, “The
<interface properties> Parameter Bit Fields,” below.
Set Serial Interface Properties Command
The Set Serial Interface Properties command is used to change the properties of a given
interface:
[B8 xx 02 0A 40 00 <interface ID> <interface properties> ]
Table 4-7: The
<interface ID>
Parameter Values
Interface ID Description
0 Serial debug interface
1 Payload interface
Table 4-8: The
<interface properties>
Parameter Bit Fields
Bits Name Description
0-3 Baud Rate ID The baud rate ID defines the interface baud rate as
follows:
0 – 9600 bps
1 – 19200 bps
2 – 38400 bps
3 – 57600 bps
4 – 115200 bps
4-6 NA Reserved
7 (MSB) Echo On If this bit is set, the IPMC enables echo for the given
serial interface.