1171
5
4.) Remove the two-piece 1/2 inch inside diameter clamp collar. Remove the bolts that
hold the nylon pad and then remove the pad. Slide the front motor bracket into place over the
top of the threaded rod and then reposition the nylon pad over the mounting flange of t he
bracket. Replace and tighten the bolts. Replace the collar clamp. Attach the rear motor
mounting bracket with 3/8” bolts and nylon lock nuts as shown in Figure 3. Leave bolts loose.
Slide on the coupler over the main rod of the AAG. Slide the motor drive rod into the top of the
coupler while placing the motor in position as shown. Attach the motor with a 3/8” bolt , flat and
lock washer on each side as shown. Tighten the collar clamp while pushing it against the nylon
pad. Align the coupler over the holes in the rod and the motor shaft. Insert two #1/4-20 bolts
with washers through the two holes. Tighten with nylon nuts. Check alignment of motor and
tighten the rear mounting bracket and all bolts that have been removed and placed. See
illustration below.
