BoardWalk Ramp and Platform Assembly Instructions
7
Inset the
square-necked carriage bolts
(#E) into the
square
holes
next to the
alignment tabs
(from the inside of the casting
out). Align the corner of the
lumber
(#A) into the corner of the
vertical and horizontal board alignment tabs
in the
BoardWalk
casting
(#B). Repeat with the other piece of
lumber
(#A) on the
opposite side of the
vertical alignment tab
.
*Note:
A clamp may
be necessary to evenly locate the lumber against the vertical
alignment tab.
vertical board alignment tab
horizontal board alignment tab
Repeat steps two and three for the opposite side casting for the
other side of the
lumber
(#A).* *Depending on lumber shape,
clamping the boards together may be required to install left
Boardwalk casting.
Drive four
deck screws (#10 x 5 1/4)
(#C) into the board through
the countersunk holes in the
casting
(#B). *Note: Apply wood
glue to each screw prior to driving into lumber.
Repeat for all necessary
Attachment-Ready
BoardWalk section
assemblies
(#2)
that are needed to meet the correct 1:12 ratio.
STEP 2
STEP 4
STEP 3
STEP 5
ATTACHMENT-READY SECTION
A.
2.
E.
B.
E.
A.
D.
C.
C.
B.
