psmailers.com • 800.464.5030
PS
M
ailers
™
PSM10K
13
Feed Table Setup
Setting the Feed Gauge
Make sure that the
power switch
is in the
off
position.
To properly
set the Feed
Gauge
System,
refer to
Figure 10.
1. Remove all paper from the feed table.
2. Insert the provided
3/16˝ T-Handle Hex Driver (inside tool kit)
into
Feed Gauge Adjustment Screw.
3. Turn the T-Handle 1/4 turn clockwise to loosen the
Feed
Gauge Wheel.
4. Place one form on the feed table and hand feed the form
about 2˝ into the machine by moving the feed belt with
your hand.
5. Turn the T-Handle 1/4 turn counter-clockwise.
6. Pull the paper out of the machine. You should feel resistance,
but not too much. Repeat steps 4-6 until there is a moderate
amount of resistance when pulling the form out. If it feels too
tight, turn the T-Handle 1/4 turn clockwise.
7. Return the T-Handle to the tool kit.
Figure 10: Feed Gauge Cross Section
Feed Gauge
Adjustment Screw
Feed Gauge Belt
Feed Gauge Roll
(#3 Roller)
Move Feed Belt,
with your hand,
in this direction
to hand feed the
form into the
machine
Summary of Contents for PSM10K
Page 1: ...PSMailers PSM10K Operating Manual...
Page 2: ......
