Psion Teklogix Vehicle-Mount Computer 8255, User Manual, Page: 43 / 348

Teklogix 7035, 8255 & 8260 Terminals User Manual
17
Chapter 2:Assembly And Basic Operation
Attaching The 7035 Hand-Strap Or The Pistol Grip
2.2.3 Attaching The 7035 Hand-Strap Or The Pistol Grip
Note: For a list of additional accessories, refer to “Accessories List” on
page 222.
2.2.3.1 Attaching The Hand Strap
Note: A Phillips head screwdriver is required.
Teklogix recommends that the hand strap provided with your terminal always be
used. However, if your terminal has an internal scanner and you plan to use the
pistol grip accessory, a hand strap is not required.
Each end of the hand strap has two holes drilled in it. The holes nearest the outer
edges of the hand strap allow the hand strap to be installed more loosely while
the holes closer to the centre of the strap provide a tighter fit. The hand strap
can be secured either on the left or the right side of the terminal, depending on
operator preference.
Two black #4-40 Phillips head screws are provided with the hand strap for
attachment. Four threaded inserts are available on the back of the terminal. The hand
strap can be attached either to the upper- and lower-most inserts on the left side of
the terminal or to the upper- and lower-most inserts on the right side of the terminal.
To attach the hand strap, choose on which side of the terminal the hand strap is to be
attached and securely fasten the screws into the back of the terminal.
2.2.3.2 Attaching The Pistol Grip
Note: A Phillips head screwdriver is required.
The four threaded inserts in the upper part of the terminal casing are used to attach
the pistol grip. Four black #4-40 Phillips head screws are provided with this
accessory.
Note: Prior to installation, make sure the trigger mechanism has been securely
snapped into the pistol grip body and the trigger operates properly.
Position the pistol grip so that it fits snugly over the back of the terminal and the
holes on the terminal and pistol grip are aligned. Using a Phillips screw driver,
securely fasten the pistol grip to the back of the terminal.