#PKSPRTXX
PSI Woodworking Products
Assembly
• Layout Parts according to diagram A. Remove stylus tip and coupler from stylus holder (if attached).
• *To prevent damage from pressing see Diagram C, place smaller bushing over the tip of the Stylus
Holder and press into the smaller side of the turned barrel. Keep bushing on stylus holder for the next
step.
• Insert extension of larger bushing into the opening at the top of the Device Holder down to the fl at recess.
Use the bushing to press the Device Holder into the larger side of the barrel.
• Install Stylus Tip onto Stylus holder and screw on coupler.
• Insert Sliding Clamp, threaded side fi rst into the Device Holder. Twist Stylus Holder counter-clockwise to
retract clamp into the Device Holder.
To use (see in use), place device in opening in Holder. The angle of the screen can be adjusted by sliding
the device up or down. When desired angle is reached, turn the stylus holder clockwise to lock clamp
against device. Do not overtighten, it could damage device. Place device on any fl at surface with holder
located on the side or top of screen. Device will balance for hands-free viewing.
Diagram D / Bushings #PKSPRTBU
© 2016 PSI Woodworking Philadelphia PA 19115 - v04/16
ø .456”
ø .638”
ø .345”
ø .345”
Turning the Blank
• Mount the bushings and blanks according to diagram B.
• Thread on the knurled nut and hand tighten to hold all components in place.
• Slide the Tailstock up snugly against the Mandrel shaft, inserting the live center point into the Mandrel
dimple. Lock Tailstock.
• Hand tighten the quill adjustment on the tailstock to steady the mandrel. Do not overtighten, it could dam-
age the mandrel shaft.
• When using Mandrel Saver, there is no need for extra spacer bushings or the knurled nut. Slide tailstock
directly against bushings and tighten until blank and bushings are secure.
• Using sharp tools, turn the blank down close to the bushing diameter. Turn the barrel straight or to a pro-
fi le of your choice.
• Sand the blank down to be fl ush with the bushings, gradually increasing sandpaper grits.
• Finish the barrel using your choice of polish. Allow Suffi cient time for the polish to cure—refer to polish
instructions.
DIAGRAM B / TURNING THE BLANKS
Mandrel Saver
Or
Live Center
Blank
Finished
Profi le
Knurled Nut
Spacer
Bushings
Tip
Bushing
End
Bushing
Short bushing
Long bushing
Remove rubber stylus tip
Diagram C / Pressing Parts
