Interface Features
Product Reference Guide
3-25
RS-232 Interface Features — cont.
NAK Character
START
MODE
BARCODE
Sets the NAK character from the set of ASCII charac-
ters or any decimal value from 000 to 255. Pad
entries of less than three digits with zeros, as in
“005”. To configure this feature, scan the “START” bar
code above to place the unit in Programming Mode,
then the “Set NAK Character,” followed by the digits
from the Alphanumeric table in
Appendix C, Alpha-
Numeric Pad
representing your desired character.
Exit programming mode by scanning the “END” bar-
code below.
DEFAULT SETTING FOR THIS FEATURE: 021
Set NAK
Character
END
Summary of Contents for LINEAR IMAGER 7000
