PS Engineering
PMA8000BT Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-890-0702
Page 2-1
Rev. 1, Oct. 2010
Section II - INSTALLATION
2.1 GENERAL INFORMATION
2.1.1
SCOPE
This section provides detailed installation and interconnection instructions for the PS Engineering
PMA8000BT Audio Selector Panel/Intercom/ with internal Marker Beacon.
Please read this manual carefully before beginning any in stallation to prevent damage and post-
installation problems. Installation of this equipment requires special tools, test equipment (refer to section
2.12.1) and knowledge as required by 14 CFR 65.81 (b).
2.1.2
Certification Requirements
NOTE
The PMA8000BT requires specialized knowledge and tools for an effective installation. An appropr iately
rated Certified Aircraft Repair Station
must
install this equipment in accordance with applicable regul a-
tions. PS Engineering, Incorporated warranty is not valid unless the equipment is installed by an author-
ized PS Engineering, Incorporated dealer.
Failure to follow any of the installation instructions, or installation by a non -certified individual or agency
will void the warranty, and may result in an
unairworthy
installation.
2.2 Unpacking and Preliminary Inspection
Use care when unpacking the equipment. Inspect the units and parts supplied for visible signs of shipping
damage. Examine the unit for loose or broken buttons, bent knobs, etc. Verify the correct quantity of
components supplied with the list in Section 1.6 (B). If any claim is to be made, save the shipping mat e-
rial and contact the freight carrier. Do NOT return units damaged in shipping to PS Engineering. If the
unit or accessories show any sign of external shipping damage, contact PS Engineering to arrange for a
replacement. Under no circumstances attempt to install a damaged unit in an aircraft. Equipment returned
to PS Engineering for any other reason should be shipped in the original PS Engineering packaging, or
other UPS approved packaging.
2.3 Equipment Installation Procedures
2.3.1
Cooling Requirements
Forced air-cooling of the PMA8000BT is not required. However, the units should be kept away from heat
producing sources (i.e. defrost or heater ducts, dropping resistors, heat producing avionics) without ade-
quate cooling air provided.
2.3.2
Mounting Requirements
The PMA8000BT must be rigidly mounted to the instrument panel of the aircraft stru cture, within view
and reach of the pilot position(s). Installation must comply with FAA Advisory Circular AC 43.13-2A.
The unit may be mounted in any area where adequate clearance for the unit and associated wiring bu ndle
exist.
To prevent noise, avoid installing the unit close to high current devices or systems with high -voltage pulse
type outputs, such as DME or transponders. Avoid running the interconnecting bundles near any high
current wires.
2.3.3
Audio Panel Mounting Rack Installation
Remove the unit from the mounting tray by unscrewing the 3/32" hex-head screw that is in the center of
the unit. Use caution to avoid hitting the photo-detector lens. Carefully slide the unit free of the tray. Set