PS Engineering PMA450, System Installation And Operation Manual, Page: 10 / 41

PS Engineering
PMA450 Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-450-0000 Page 2-3 Rev. 6, Dec. 2015
Radiated signals can be a factor when low level microphone signals are "bundled" with current carrying
power wires. Keep these cables physically separated. It is very important that you use insulated washers to
isolate the ground return path from the airframe to all headphone and microphone jacks.
2.4.1.1 Music Inputs and Noise
PMA450 units utilize a differential input to help prevent noise from entering the music system. This feature
is usually transparent to the installer; however, it is important that the appropriate music signal and ground
connections are made directly to the dedicated music signal and ground inputs on the PMA450. The power
for IFE and audio panel should be a common bus.
If a music jack instead of a music source is installed for Music 1 or 2, we recommend grounding the jack to
airframe ground.
NOISE NOTE
Adding a high-performance audio control system, particularly in conjunction with high-performance active
noise canceling headsets, cannot improve on older avionics that were designed for cabin-speaker use. PS
Engineering makes no claim that the audio panel will provide a noise-free audio quality under all installa-
tion conditions, particularly with older avionics.
2.4.2 Existing GMA340 and PMA8000 Installations
If the installation replaces a GMA340 or any of the PMA8000 series, no changes are necessary as long as
the existing installation meets the requirements (applies to S/N E01150 and above). All existing functions
of the GMA340 as afforded by the PMA450 will become instantly available. However, if the previous in-
stallation had three COMs, the PMA450 will not support the third COM, the PMA450 handles only two
COM transceivers. The PMA8000C will support three coms.
2.4.2.1 Differences with GMA340 connector
Connector Pin GMA340 Function PMA450 Function
J1 3 COM 3 TEL Audio Hi
J1 4 COM 3 TEL Lo
J1 5 COM 3 TEL Mic Audio Hi
J1 6 COM 3 No Connection
J1 16 MASQ Inhibit No Connection
J1 23 COM 3 Speaker Load AUX Audio Input
J1 24 COM 3 Speaker Load CNX80 Inhibit
J1 25 COM Speaker Load No Connection
J1 26 COM Speaker Load No Connection
J1 27 COM Speaker Load No Connection
J1 28 COM Speaker Load No Connection
J1 29 No Connection Unswitched #3
J2 15 High Music Gain Select Unswitched #4
J2 17 8Ω Speaker Select No Connection
J2 18 No Connection Aux Enable Output
J2 19 Tone Enable PA Enable
J2 29 Failsafe warn No Connection
J2 30 Com TX Mute No Connection
Table 2-2 GMA340–PMA450 connector differences
Installations where the external marker outputs are connected to a Sandel 3308 Navigation Display will
require additional loading resistors. Refer to the Sandel installation data for more information.