4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
Owner’s Guide 6
Owner’s Guide
©2013 PS Audio International Inc. All rights reserved.
®
Owner’s Reference
NuWave Phono Converter
to install a driver, that same driver is built into Mac’s running OSX. Once connected to the USB
input on your computer, it will be necessary to activate the USB output from the front panel of the
NPC. Detailed instructions are included later in this manual.
Between the Firmware input and the Coax digital output is a small hole in the rear panel labeled
RESET. Activating this function will reset all settings on the NPC back to factory defaults. The
NPC will remember all user settings once selected. If you make some selection and find yourself
lost or cannot get back to where you were through the front panel controls, certainly an unlikely
situation, you can activate the RESET button at any time. Use a small object such as a ballpoint
pen, pencil or toothpick to press the recessed internal button for 2 seconds if necessary.
The normal default mode for the front panel display is off. To conserve the longevity of the OLED
screen for many years, the NPC will turn its display to off after 24 seconds of display. To reactivate
the display, simply press any of the four front panel buttons. Once activated, the display will
remain active for approximately 24 seconds.
There are two sets of front panel buttons: MODE up and down and SELECT up and down. The
MODE buttons are on the left side of the display screen.
The MODE toggles through the 7 available menu screens.
• Play
• Input
• A/D Mode
• PCM or DSD sample rate
• Gain
• Brightness
• Version
The PLAY screen offers two menu choices: In phase/Out of phase and stereo/mono. The top
SELECT button chooses between In Phase and Out of Phase. The bottom SELECT button
chooses between Stereo and Mono.
Reset Function
Front panel
Controls
Play Screen
