Pict. 9 - How to tune the nozzle height in real time during the test print. Note: -0.640 mm is
only for illustration.
Your setting will be different!
Observe the line which is being extruded on the print surface. A new menu will automatically
show up, with an option to tune the nozzle height in real time by turning the knob. The aim is
to adjust the nozzle height until the extruded plastic sticks nicely to the bed and you can see
that it is being slightly squished. The value should not exceed -2.000 mm.
If you have to
adjust it more (e.g. -2.500), move the P.I.N.D.A probe slightly higher. Please refer to
our knowledge base in case the P.I.N.D.A probe needs to be realigned.
Pict. 10 - The properly-tuned first layer
12
Summary of Contents for Original Prusa i3 MK2.5
Page 1: ......
