Multipoint measurement
This mode is used to measure shafts which are either difficult to turn continuously or allow meas-
urement only in certain rotational positions. The method can also be used to measure uncoupled
shafts, nonrotatable shafts, sleeve bearings, white metal bearings and journal (radial) bearings, shafts
that are difficult to turn, shafts with herky-jerky rotation, situations with long spans or severe mis-
alignment that will readily cause the beam to fall out of range.
If not yet completed, enter machine dimensions, then center laser beam.
1) 'Next' icon – tap to take initial measurement point
2) Hint to tap 'Next' icon
Tap
the 'Next' icon to take the initial measurement point then rotate the shafts in their normal
direction of operation, to the next measurement position.
1) Coupling area to be tapped to take measurement
2) Number of points already taken
3) 'Cancel' icon – used to cancel current measurement and start new measurement
Tap the coupling area [
1
] to take the measurement point. Rotate shafts further, taking measurement
points by tapping the coupling area [
1
]. Take as many measurement points through as wide a rota-
tional angle as possible.
FictionSoft
21
(Undefined variable: General.UserGuideTitle)
