- 13 -
A clearly laid out table at the rear of the device
makes it easy to pre-select the rotational speed
or sanding speed for the appropriate material.
The high-quality aluminium sanding table can
be adjusted to tilt up by 10° and down by 50°. A
scale makes it easy to read the angle. This also
contains the guide groove of the angle stop that
is also included in the delivery.
It is even possible to accurately refinish small
turning steels, sharpen chisels and knives, re-
sand screwdriver edges, etc. ...
Delivery includes two sanding discs of 80 and 240
grit each. A silicone film was attached to the sand-
ing disc to guarantee best sanding disc exchange
(e.g. while working with different grits).
A suction connection for the vacuum cleaner
makes sure that sanding dust has no other
place to go but in the vacuum cleaner. This
presents the best equipment for any occurring
sanding work.
3 Scope of delivery:
1 pc. Disc sander TSG 250/E
1 pc. Angle stop
1 pc. Rubber connecting piece for vacuum
cleaner connection
2 pc. Sanding discs 80 grit
2 pc. Sanding discs 240 grit
2 pc. Storage discs
1 pc. Operating instructions
1 pc. Brochure with safety regulations
1 pc. Device packaging
4 Legend (Fig. 1)
1. Speed controller
2. On/Off switch
3. Sanding table
4. Clamping screw angle stop
5. Angle stop
6. Scale angle stop
7. Housing
8. Mains cable
9. Connecting piece for vacuum cleaner
10. Clamping screw of angle adjustment
11. Scale of angle adjustment
12. Indicator
13. Protecting cover
14. Sanding disc
15. Mounting connection for cooling system
16. Connecting piece for coolant hose
5 Technical data
Sanding speed:
250
– 750 m/min
Sanding disc:
Ø 250 mm
Table adjustment:
tilts 10° up, 50° down
Noise level:
72 dB(A)
Vibration:
<= 2.5 m/s²
Work table:
275 x 105 mm
Overall size (without table)
(L x D x H):
270 x 280 x 330 mm
Motor:
Voltage:
220
– 240 V 50/60 Hz
Power consumption:
KB 15 min
Use only in closed rooms!
Do not dispose of the electrical device
in the household waste!
6 Commissioning the device
6.1 Setting up your disc sander:
Note:
When setting up the device, always make sure
you have a level and firm surface! Secure stabil-
ity is indispensable for working with the device!
Note:
When setting up and fixing the device, always
disconnect the mains plug to prevent the disc
from starting up inadvertently. Risk of injuries!
1. Remove the disc sander from the packaging
and check if the scope of delivery is com-
plete.
2. Fasten the device with the fastening screws
to a sturdy workbench or worktop (see Fig. 2)
as per the master gauge for holes in Fig. 2a.
6.2 Removing and attaching the sanding
table (Fig. 3):
Attention:
Before removing and inserting the sanding table,
always disconnect the mains plug to prevent the
disc from starting up inadvertently. Risk of injuries!