- 9 -
part of the scope of supply).
Working with the carver:
WARNING!
Do not switch on the unit when it is under load (axial pressure). Do not
work without protective glasses.
1. Firmly secure the work piece.
2. Turn on the unit at the switch 1 (Fig. 1).
3. Hold the unit such that the ventilation slots 5 (Fig. 1) are not cove-
red.
4. Guide the unit with light hand pressure (Fig. 4) and avoid strong
pressure. You can achieve cleaner work results if you let the unit
cut through the material by itself without much pressure.
Immediately switch off the machine and allow it to cool down if it
has overheated.
WARNING!
Always work moving away from the body and never hold your fingers
or hand (Fig. 3) in the direction of cutting. You could hurt yourself if
you slipped. Work as shown in Fig. 4!
Note:
Trace or draw the design motif before starting the work on the work
piece and cut it out roughly.
You can find technical books and templates at your bookstore. You will
also find usual information about materials and working techniques in
our "Manual for Creative Model Makers" with part number 28 996.
Care and maintenance
WARNING!
Always pull out the mains plug before any work!
Always ensure that the ventilation slots are clear.
Check the mains cable at regular intervals for damage. Have it repla-
ced by a technician if it is damaged.
No special maintenance is required for your motorised carver apart
from occasional cleaning. If you follow the notes in these operating
instructions, the unit will give you long, reliable, safe and valuable ser-
vice.
WARNING!
Please do not dispose of the device in domestic waste! The device
contains valuable substances that can be recycled. If you have any
questions about this, please contact your local waste management
enterprise or other corresponding municipal facilities.
EC DECLARATION OF CONFORMITY
Name and address of producer:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Description: Motorised carver SGM
Model No.: 28642
We declare that the designated equipment complies with the following
EC Directives:
EC Low Voltage Directive
73/23/EEC
Applicable standards:
DIN-EN 60745-1 – 12.2003
EC-machine directive
98/037/EEC
According to standards:
DIN-EN 60745-1 – 12.2003
EC EMC Directive
89/336/EEC
Applicable standards:
DIN-EN 55014-1 – 08.2002
DIN-EN 55014-2 – 08.2002
DIN-EN 61000-3-2 – 12.2001
DIN-EN 61000-3-3 – 05.2001
Date:
22.11.2004
Signature:
Position:
Research & Developement
Name:
Jörg Wagner
WWW.PROXXON.RO
