Proximity
UVC-SA
SET-UP
REV G /2021
P3
Step 1:
Note:
Rotation Stop
Step 2:
Locate pre-assembled portion
Install 2 supplied
screws.
Step 4:
Plug In Power
Step 5:
Hang bracket
onto stand
Step 3:
Plug In Power
0 degrees
15 degrees
(FLAT SQUARE)
This part will minimize
free rotation.
Long screw
holds rotation position with a
small amount of pressure.
Tighten until firm only.
Long
Short
‘Level’ or, O degrees
of rotation is
recommended for
this model.
As shown above.
Insert the power cable wire through the
cable hole located near the top of the stand. Continue the
cable down the back of the stand.
Tie the cabling in place.
Power is on.
(supplied adapter
or a USB 3.0.)
(Factory
Installed)
