All rights reserved
Page 13
step 3: connect the cables
If you have not already done so, connect the normal RJ45 connector on an
outdoor-rated CAT5 cable to the “Data and Power Out” port on the power
injector.
Note:
On FC versions, connect the cable to the port labeled “J1 Antenna” on the
power injector (not pictured). This port has 48 VDC power on the RJ45.
Attach the other end of the CAT5 cable with RJ45 connector to the Power
and Ethernet port on the back of the unit (see the following figure). Note
that the first attachment of this cable is meant to verify operation and
configure the unit; the final attachment (with proper torque values) and
weatherproofing are to be done after the unit has been installed in the
location at which it will operate (
See Step 7: Complete Installation
).
Caution!
Do.not.over-tighten.the.connector.nuts;.do.not.use.a.wrench.to.
tighten.the.connectors!..
1.
2.
