All rights reserved
Page 21
Note:
If your Access Point does not appear in the Scan List, click the
Rescan
button to update the display. If the unit still does not appear in the list, see
the Troubleshooting chapter in the
AP-4900MR-LR User Guide
for suggestions.
Note that after rebooting an Access Point, it may take up to five minutes for
the unit to appear in the Scan List.
Do one of the following:
If the AP has been assigned an IP address by a DHCP server on the
network, write down the IP address and click
Cancel
to close ScanTool.
Proceed to the
Logging In
section below for information on how to access
the HTTP interface using this IP address.
Note:
Mesh APs must be configured with static IP addresses. To assign the AP a
static IP address, follow the steps below.
If the AP has not been assigned an IP address (in other words, the unit
is using its default IP address, 169.254.128.132), follow these steps to
assign it a static IP address that is valid on your network:
Highlight the entry for the AP you want to configure.
Click the
Change
button. The Change screen appears.
Set
IP.Address.Type
to Static.
3.
▪
▪
a.
b.
c.
