Proware Epica, User Manual

Page: 226 / 240

NAS System
226 User Manual
12.2.2 Procedure for Setting Up proNAS HA
Setting up a server cluster:
Below are the basic steps in setting up a server cluster:
1. Configure the hostname for both proNAS servers (must be unique).
2. Configure two static IP addresses for each proNAS server.
3. Set up private net. At least the private net IP must be configured to start cluster.
4. Start proNAS HA service for both proNAS servers. You may do this under System
Manager then Services tab, highlight proNAS HA service then click Start. proNAS
HA node will then appear on the left tree after it starts successfully.
5. On the designated Active Server, go to proNAS HA->"General Settings".
6. On the "General Setting" tab, click "Edit" button. Input the Peer Server hostname
then select "
Active (local-host) – Standby (peer host) Mode " under the
Cluster mode. Click "Save".
NOTE: The Cluster Mode of Backup Server must be configured as
“Standby(local host) – Active(peer-host) Mode” (see Step 10).
Other configuration options:
Computer Name:
Local Server: The hostname of the Active or Primary server
Peer Server: The hostname of the Backup or Secondary server